Gallery: DIY: How to Make Your Own Storage Bed Using a Repurposed IKEA ...

Note: This pic actually shows a longer storage platform that I created out of 2 Ikea bookshelves but the idea is pretty much the same. STEP 2: Carefully lay your bookcase on its side (you might want to enlist some help with this). After your plywood
Note: This pic actually shows a longer storage platform that I created out of 2 Ikea bookshelves but the idea is pretty much the same.

STEP 2:

Carefully lay your bookcase on its side (you might want to enlist some help with this). After your plywood sheets are dry, place them on top of the bookcase so that they form a platform. Line up the seam where the two sheets meet with the middle shelf of the bookshelf's grid. Width wise, they should overlap the bookcase by just a few inches so that there is a lip for your fingers to catch when you need to lift them up and access your stuff. Lengthwise, they should overlap the edges of the bookshelf by about 9" on either side.

STEP 3:

This next step helps keep the wooden panels locked nicely in place instead of sliding around under you while you sleep. With your configuration set up just the way you like it, look underneath the overhang of your plywood sheets and use a pencil to mark an outline of the bookshelf on the undersides of the panels. Then remove the sheets of plywood and cut eight 2" pieces of velcro. Adhere the velcro to the top edges of your bookcase in eight equally spread out locations and then peel off the sticky backs. Finally, replace the plywood sheets ever so carefully and press down so that they stick.

Read the rest of this entry »

LEAVE A COMMENT

or your inhabitat account below



5 Comments

  1. Koh EL November 29, 2013 at 2:36 am

    Has anyone tried this yet? Which Ikea shelf to purchase and what type of bed size to fit the setup?

  2. greenapples September 9, 2013 at 1:10 pm

    im just curious how much weight it can hold up- Esp if a queen mattress is used and two people are sleeping on in

  3. jsgittens August 17, 2012 at 12:28 pm

    Could you use a queen sized mattress in a similar way with this DIY?

  4. cibi July 18, 2012 at 11:20 am

    Nice idea, but don’t forget to drill holes in the plywood or you will have condensation between the mattress and the plywood and mold will grow…

  5. Marc Carter July 10, 2012 at 11:21 am

    This is a perfect and inexpensive way to store seasonal items, like sweaters that aren’t used in the crazy NYC summer months!